Hydraulic System

Hydraulic Swing Clamp Cylinder    Bore:ø25-ø63 mm    Pmax:100 kg/cm2

Product Introduction

  • The product is ideal for mass production on a special purpose machine and jig on machining center. It will greatly upgrade production efficiency.
  • When the hydraulic cylinder actuate, and the piston moves downward, the clamping arm will swing to a rated angle! Then it lowers until the workpiece is clamped securely.
  • To avoid too fast motion a flow control valve is suggested to connect to the hydraulic swing clamp cylinder. Do not clamp workpiece while the clamp is swinging to avoid damaging on the cylinder barrel and internal parts.
  • When increasing length of clamping arm is required, be sure do not exceed 1.5 times of the ariginal length.
  • The cylinder body is manufactured from structral carbon steel. Surface is specially treated for maximum smoothness on inside surface and long service life.

Ordering Code

Specifications

Single Side Swing Clamp

Double Side Swing Clamp

Clamping Arm Mounting Methods

Clamping Arm Removing Methods



Line type    Bore:ø25-ø63 mm    Pmax:100 kg/cm2

Dimensional table



Manifold with flow control    Bore:ø25-ø63 mm    Pmax:100 kg/cm2

Dimensional table



Manifold type    Bore:ø25-ø50 mm    Pmax:100 kg/cm2

Dimensional table



Flange type / Threaded    Bore:ø25-ø63 mm    Pmax:100 kg/cm2

Dimensional table



Flange with manifold    Bore:ø25-ø63 mm    Pmax:100 kg/cm2

Dimensional table

Online Inquiry