H. P. T. M. Patent Empty Oil Conversion Combination Series
Feature
- Modular , high stability and precise.
- Features can be arbitrarily set , change combinations.
- Low cost , energy saving , easy installation.
Circuit Constituting The Note
Reciprocating actuation , when only a single side of the actuator control, see figure a. Assembly methods. A set of transformations simultaneously control two or more cylinders , see figure b. Configure , only two or more simultaneous operation , and if using a single valve device , you can not use two or more cylinders simultaneous operation , will produce successively activating support segment difference. When attached to the combination valve of the velocity shift converter , the speed switching valve actuation , it is because there is no control valve , the speed will depend on such factors bore size, piping conditions , and when the cylinder bore is small , with reference to FIG. c. Installation air flow control valve with a large adjustment. Reciprocating who must use the shut-off valve , for intermediate stop , be sure to use a combination of the cylinder before converting the rear column in figure d..
Example Description
Installation On The Note
1. Installation: be sure to install the converter is set upright, another oil conversion device shall be within the lower limit higher than the upper limit of some pneumatic cylinders.
2. Piping :
A . Be sure to pay attention to before piping clean, does not have oil extreme differences caliber pipes occur.
B . Set in the pilot pressure 3 kg or more, or a maximum of working pressure used in order to ensure that the actuator valve means.
3 . Air source：to prevent the shortening of life so immersed in the drainage of oil produced actuator, please install a multi-front converter filter better.
4 . Fluid：working oil to the hydraulic oil system of hydraulic oil turbine oil is the best oil to use for a viscosity of about 40 ~ 100 cSt.
5 . Operating temperature：ISO VG32 to 15 ~ 35 ˚ C.
6 . Way valve actuation of the actuator：Limiting valve and shut-off valve is fully series valve device , the boot can be replaced with pure pneumatic or electromagnetic actuator guide , the guide also patented biaxial pure pneumatic actuator type, front and rear brakes can be easily positioned to install , or use the front and rear cushion.
Valve means purpose specification
| Limiting valve \ shut-off valve |
Without control valve | Individual control valve | Shut-off valve | Purpose | |
|---|---|---|---|---|---|
| Unlimited valve |  |
 |
 |
Full become governor Without speed or position | |
| Limiting valve |  |
 |
 |
It can be used for speed conversion Speed adjustment | |
| Purpose | Bidirectional speed control | It can be used for one-way jog control | Can intermediate stop , emergency stop | ||